en English

SCPLUS NEWS, Blog, FAQ, Supports, Technique

How To Install Heat Transfer Felt By 7 Steps

1.Disassemble the parts

Tear down the Nuts,Roller and other parts.

heat transfer felt

2.Remove the two sides of the motor and some parts

Open the door of chassis on both side,disassemble motors and other parts.So that take out the roller.

heat press felt

3.Take out the roller

Take out the roller that needs to be disassembled.

heat press temperature for felt

4.Unloading heat transfer felt

After disassembling the roller,install new heat transfer felt replacing the old one.

heat press temp for felt

5.Installation of auxiliary roller

After replacing felt,install the auxiliary roller originally to the specified position.

heat press setting for felt

6.Fix the parts

After heat transfer felt is installed, fix the nuts and other accessories.

heat transfer printing felt

7.Debugging heat transfer felt

After completing the above steps, you can start the machine to debug.Open the boot, the felt turns forward and backward. Close the volume, unwind the roll. Warm up every 2 hours,idling,120℃,150℃,80℃,230℃,240℃,tap slightly after warming up,when there is a little relaxation,slightly repeated tension. After idling for 10 hours,If the requirements are higher, then continue to idle,The longer the heating time, the effect more stable.Always observe the machine’s correcting device,and be sure to keep it running straight. Once the temperature is high, the felt is basically shaped,It’s not easy to adjust the deviation.It’s better to observe at any time within 10 hours. Tips:Butter can be used to remove rust at 300℃ for Maintenance.

heat transfer felt